YORK LOCK & KEY CO., INC.
                               1554 ALTON ROAD
                           MIAMI BEACH, FL. 33139

                 INSTRUCTIONS FOR SETTING NEW COMBINATION 
                  FOR UNICAN 1000 SERIES ACCESS CONTROL


STEP 1
        THE DOOR MUST BE OPEN.  ON MODELS WITH PASSAGE SET FEATURE, MAKE
        SURE THE UNIT IS IN THE LOCKED MODE (FEATURE DISENGAGED) ACTUATOR 
        IN THE VERTICAL POSITION. INSERT THE CONTROL KEY (DF-59) INTO THE
        INSIDE CYLINDER AND UNSCREW THE CYLINDER BY TURNING IT COUNTER-
        CLOCKWISE.  REMOVE THE CYLINDER TO COMPLETELY GAIN ACCESS TO THE
        COMBINATION CHANGE SLEEVE.

STEP 2
        TURN THE OUTSIDE KNOB CLOCKWISE (ALL THE WAY UNTIL IT STOPS) THEN,
        RELEASE.

STEP 3
        PRESS IN THE EXISTING COMBINATION.  AS THE BUTTONS ARE PRESSED A
        SLIGHT CLICK SHOULD BE FELT.

STEP 4
        A       INSERT PROVIDED SPANNER WRENCH INTO COMBINATION CHANGE SLEEVE
                THROUGH OPENNING ON INSIDE OF LOCK.

        B       TURN GENTLY CLOCKWISE UNTIL STOP (A SLIGHT CLICK SHOULD BE 
                HEARD).

        C       TURN COUNTER-CLOCKWISE UNTIL STOP.

        D       REMOVE SPANNER WRENCH.

STEP 5
        TURN THE OUTSIDE KNOB CLOCKWISE (ALL THE WAY UNTIL IT STOPS) THEN,
        RELEASE.

STEP 6
        CHOOSE YOUR NEW COMBINATION, WRITE IT DOWN ON PAPER AND THEN PRESS 
        BUTTONS IN CAREFULLY (A SLIGHT CLICK SHOULD BE FELT AS EACH BUTTON 
        IS PRESSED).

        NOTE:   YOU CAN USE ONLY ONE BUTTON OR AS MANY AS FIVE BUTTONS FOR A
                COMBINATION.  BUTTONS MAY BE PRESSED SIMUTANEOUSLY OR 
                SUCCESSIVELY, BUT THE SAME BUTTON CAN NOT BE USED MORE THAN 
                ONCE IN THE SAME COMBINATION.

STEP 7
        TURN THE KNOB CLOCKWISE ONCE, ALL THE WAY, UNTIL IT STOPS, AND 
        HOLD IT IN POSITION TO CHECK IF LATCH IS RETRACTED ALL THE WAY.
        RELEASE KNOB AND TURN CLOCKWISE AGAIN, ALL THE WAY, THE LATCH 
        SHOULD NOT RETRACT THIS TIME.  PRESS NEW COMBINATION AND TURN
        AGAIN THIS TIME THE LATCH SHOULD RETRACT.

STEP 8
        REPOSITION INSIDE CYLINDER BY SCREWING IT ON CLOCKWISE WITH THE KEY
        **************** D O   N O T    O V E R T I G H T E N **************
        THEN, REMOVE THE KEY AND STORE IN SECURE AREA WITH THESE INSTRUCTIONS 
        AND SPANNER WRENCH.  (KEY CAN ONLY BE REMOVED IN VERTICAL OR 
        HORIZONTAL POSITIONS).